Root > Troubleshooting > Installation problems > EurekaLog IDE Setup

EurekaLog IDE Setup

Previous pageReturn to chapter overviewNext page   

EurekaLog performs the following steps to install itself for each IDE:


1. For each IDE EurekaLog installs a set of dcu/obj/hpp files into %EurekaLog%\Lib\Win32\Debug\Your-IDE\ and %EurekaLog%\Lib\Win32\Release\Your-IDE\ folders.
2. EurekaLog copies EurekaLogCoreVER.bpl, .dbg, .jdbg files from %EurekaLog%\Packages\Your-IDE\ folder to Windows\System32 folder (of corresponded bitness).
3. EurekaLog registers itself into IDE:
Adds EurekaLogExpertVER.bpl package (Component\Install package);
Adds EurekaLogComponentVER.bpl package (Component\Install package);
Adds %EurekaLog%\Lib\Win32\Release\Your-IDE\ to Library paths;
Adds %EurekaLog%\Lib\Win32\Debug\Your-IDE\ to Debug DCU paths;
Adds %EurekaLog%\Source\ to Browsing paths.


Refer to IDE names to know more about Your-IDE names.



See also:

Send feedback... Build date: 2023-09-11
Last edited: 2023-03-07
The documentation team uses the feedback submitted to improve the EurekaLog documentation. We do not use your e-mail address for any other purpose. We will remove your e-mail address from our system after the issue you are reporting has been resolved. While we are working to resolve this issue, we may send you an e-mail message to request more information about your feedback. After the issues have been addressed, we may send you an email message to let you know that your feedback has been addressed.

Permanent link to this article: