Root > Compatibility > 5.x -> 6.x > EurekaLog 6 Documentation > Introduction > Installation


Previous pageReturn to chapter overviewNext page   

Caution: this is old EurekaLog 6 documentation. This is not the latest version.


Before installing EurekaLog, you must close all Delphi/C++Builder instances.


Run the EurekaLog installation program and select one or more Delphi/C++Builder versions you wish to install.


Start the installation.


When installation ends, open the Delphi/C++Builder IDE and you are ready to work with EurekaLog.



Note: EurekaLog install the TEurekaLog component into the EurekaLog component palette.

Send feedback... Build date: 2021-11-08
Last edited: 2018-06-14
The documentation team uses the feedback submitted to improve the EurekaLog documentation. We do not use your e-mail address for any other purpose. We will remove your e-mail address from our system after the issue you are reporting has been resolved. While we are working to resolve this issue, we may send you an e-mail message to request more information about your feedback. After the issues have been addressed, we may send you an email message to let you know that your feedback has been addressed.

Permanent link to this article: